-40%
StarBird Landing Gear! Milton Bradley. 3D Printed Parts Only (No Ship)
$ 10.03
- Description
- Size Guide
Description
StarBird Landing Gear! Milton Bradley. 3D Printed Parts Only (NO SHIP). Condition is "New" because these are 3D printed.The Original StarBird did NOT have landing gear. I designed these in order to display my ship easier.
These are great for ships missing the "Landing/Takeoff Thrusters"!!
See photos for assembly. You will need to remove 2 screws under the wing for the rear gear.
For the front gear, these simply press fit into the screw inset hole on both the starboard and port side of the front piece. Use the holes closer to the rear of the ship. If you use the front holes, your ship will not sit level.
For the Rear Gear:
Step 1: Remove the "Landing/Takeoff Thrusters" There will be a screw under these. You will not need the original thrusters, but keep them to switch back to "no gear".
Step 2: Remove the small screw that holds the wings together.
Step 3: Place that screw into the appropriate Rear Landing Gear. Note these are mirrored and must be attached to the correct side. See photos for an example.
Step 4: Tighten the screw.
Step 5: Turn on your ship. Point it down so the engines slow down. Level off... Now go in for an easy landing!
See my other listings for more great StartBird Mods and missing pieces.
You Get:
2 Rear Landing Gear
2 Front Landing Gear
Shipped with USPS First Class.
If purchasing multiple items from my listing, select "Request Total" from the cart before paying so the shipping can be adjusted.